Use an impact driver.
Mortering sleeves into a concrete wall.
My diy way to screw brackets into cement same as brick.
How to drill into concrete to hang a tv shelves racks etc.
Screw embedment will work fine.
Another option is concrete bolts drill the right size hole and it is a self tapping bolt right into the concrete.
Use a vacuum or round wire brush to remove the debris from the pilot hole.
Install your sleve anchors.
Drop the anchor into the hole in your fixture and hammer the pin on the top of the anchor to drive it into the concrete hole you drilled earlier.
Hammer the sleeve anchor through the ledger board into the concrete wall.
Do not over tighten.
Sleeves pinch the side of the pilot hole and get tighter as the screw is driven into place.
We used to use 5 8 x 4 to crank in for bracing gang forms.
Hand tighten the bolts using a ratchet.
Hammer the anchor into the hole in the concrete.
Simply drill a hole into the concrete hold the fixture you re fastening over the hole then use a hammer to tap the anchor into the hole.
Length is measured from the washer to the end of the anchor.
Any pipe that passes under a footing or through a foundation wall shall be provided with a relieving arch or a pipe sleeve pipe shall be built into the foundation wall.
In hard dense materials like concrete or stone this minimum 1 in.
Continue to hammer the anchor down until the nut and washer are tight against the fixture.
Tighten the bolts carefully.
In this video i will show you how to drill into brick concrete and cement with a drill and also how to attach fix mount or anchor into a brick concrete or.
Pipes through or under footings or foundation walls.
Repeat this step for all the holes needed to secure the mount to the wall.
If you don t have a setting tool just flip your sds bit around and use the shank pounding it in with a hammer.
To the thickness of the material you re attaching to get the minimum length of screw needed.
As the pin is hammered in the sleeve expands outward.
Select a screw length to penetrate the concrete at least 1 in.
Install two bolts at the end of each ledger board.
Sleeve anchors masonry concrete anchors.
Next use a concrete bit to drill into the concrete wall.
Best for medium duty applications such as metal railing and grab bars set in concrete block.
It should be a fairly tight fit.