New Construction Window Installation Instructions

The flap created should be pulled up and temporarily taped to hold it up and out of the way for the window installation.

New construction window installation instructions.

New construction window installation instructions at the top corner on each side of the window measure up 6 and over 6 and mark. Prepare the opening to receive the window. If not adjust the shims until the window is square. Our installation instructions provide detailed steps on installing our window and door products.

Remove the locking pin with a screwdriver in a downward direction. If the window has a brick mold pre drill holes in it and drive 16d nails through it and into the framing. Begin by measuring the rough opening. This size may vary depending on the window opening.

Apply jamb flashing over the jamb nailing fin continuing over and beyond the sill flashing two inches below. Follow your local building codes customs and building practices for any additional installation requirements. It is then attached using frame screws or clips and sealed to the wood buck using the flush flange or brickmould. These instructions are general in nature.

New construction windows are typically installed during the early stages of construction for a new home or for a built from scratch addition to a home. Framing requirements the rough framed opening should be 1 2 inch larger than the window in width and 4 inch in height to allow for squaring and shimming of the window where necessary. This installation includes a nail fin which is fastened directly to the frame of the house requiring access to the frame studs which is why these windows are typically used in new. The manufacturer will accept no responsibility for air or water leakage above under or around the window unit.

For detailed installation instructions by product contact ply gem windows at 1 888 9plygem. Remove the window casement for a smooth installation. For typical wood frame construction. Open the casement and lift it upwards fig.

New construction installation in masonry construction for flush flange or wood brickmould windows. Measure the diagonals of the window before installing windows. Apply the head flashing similarly extending two inches past either side of the jamb flashing to complete the window flashing detail. Install batt insulation between the window and rough opening.

The window should have 1 4 and no more than 1 2 around the perimeter of the unit and must be installed plumb level and square even though the opening may not be any of these. These instructions were developed and tested for use with typical wood frame wall construction in a wall system designed to manage water with a weather resistant barrier applied prior to the window installation. Before you can start with the installation you have to prepare the new window. Always double check that.

If they are equal the window is square. These instructions are not to be used with other construction methods.